Executive’s Corner – November 2020

Executive’s Corner – November 2020

by | Nov 23, 2020

A Message from Kim Medford, ENTEK’s new President Welcome to the latest issue of Extrusion Solutions. An Introduction Hello!  In late August I was humbled and honored to be named the new President of ENTEK Manufacturing. They say we stand on the shoulders of...

ENTEK Extruders – Upcoming Events

by | Nov 18, 2020

We are hopeful that in-person conferences and shows will be taking place again in 2021.  With that in mind, ENTEK is scheduled to exhibit at the following events.  We hope to see you there!   Plastics Recycling Conference – May 3-5, 2021 – Washington DC  ...
JEDA Polymers Chooses ENTEK

JEDA Polymers Chooses ENTEK

by | Nov 18, 2020

Leading Midwest Compounder Gains Competitive Advantage with ENTEK QC3 Machinery, Vacuum Feed Technology (VFT) JEDA Polymers is a leading compounder and supplier of thermoplastics for injection molders. They offer a range of standard, specialized, and custom products...

Extruders Processing Tips – Understanding Vent Flow

by | Nov 18, 2020

Vent flow occurs when polymer and/or compound flow out of a vent opening preventing air/gases from escaping out of the extruder.  Not only can vent flow cause product defects but it can create an undesirable mess and can sometimes be an operator’s toughest challenge. ...
Translate »