by ENTEK | Nov 23, 2020
A Message from Kim Medford, ENTEK’s new President Welcome to the latest issue of Extrusion Solutions. An Introduction Hello! In late August I was humbled and honored to be named the new President of ENTEK Manufacturing. They say we stand on the shoulders of...
by ENTEK | Nov 18, 2020
We are hopeful that in-person conferences and shows will be taking place again in 2021. With that in mind, ENTEK is scheduled to exhibit at the following events. We hope to see you there! Plastics Recycling Conference – May 3-5, 2021 – Washington DC ...
by ENTEK | Nov 18, 2020
Leading Midwest Compounder Gains Competitive Advantage with ENTEK QC3 Machinery, Vacuum Feed Technology (VFT) JEDA Polymers is a leading compounder and supplier of thermoplastics for injection molders. They offer a range of standard, specialized, and custom products...
by ENTEK | Nov 18, 2020
Vent flow occurs when polymer and/or compound flow out of a vent opening preventing air/gases from escaping out of the extruder. Not only can vent flow cause product defects but it can create an undesirable mess and can sometimes be an operator’s toughest challenge. ...
by ENTEK | Nov 18, 2020
ENTEK is working to reduce cost of ownership for our customers by expanding our twin-screw extruder REBUILD, REFURBISHMENT and REPAIR SERVICES. Let us help you identify potential areas for improvement and schedule these services, which will save you time and money,...
Translate »
Recent Comments